Configuring Pxe Boot - Dell QLogic Family of Adapters User Manual

PXE Boot Configuration: QLogic QME8242 Mezzanine Card User's Guide
Back to Contents Page
PXE Boot Configuration: QLogic QME8242 Mezzanine Card User's
Guide

Configuring PXE Boot

This section provides procedures for configuring the QME8242 to perform PXE boot.
To configure PXE boot:
1. During POST, press the <Ctrl+Q> keys to enter the QLogic QME8242 CNA Function Configuration window.
2. On the Function Configuration main window, ensure that the Protocol is set to PXE, as shown in
Figure 1. QLogic QME8242 CNA Function Configuration
3. Press the<Esc> key to exit.
4. Select Save changes to save your edits, exit, and reboot the system.
5. During POST, press the <F2> key to enter the Dell BIOS system.
6. Select Boot Settings, and then press the <Enter> key, as shown in
Figure 2. Dell BIOS: Boot Settings
file:///T|/htdocs/NETWORK/QLogic/71922/en/pxe_boot.htm[9/26/2012 4:26:16 PM]
Figure 2.
Figure 1.