Setting The Date And Time - FujiFilm FinePix 50i Owner's Manual

SWITCHING ON AND OFF
1
When you switch the camera on, the viewfinder
lamp lights (green). If the date has been cleared,
a confirmation message appears.
hSET
: The DATE/TIME setting screen
appears (➡P.22).
hNO : The camera remains in photography
or playback mode.
G
!
If you do not set the date and time, this confirmation
20 screen will appear each time you switch the camera on.
2
LCD monitor Remote controller LCD panel
1 Blank 1 Blank
2 2
Lit white Blank
3 3
Lit red
4 4
Blinking red
You can check the remaining battery charge on
the LCD monitor by pressing the "DISP" button
to switch the LCD monitor on.
1Battery has ample charge (no indicator
displayed).
2The battery is approximately half charged.
3Battery charge low. Replace or recharge the
battery as it will run out shortly.
4The battery is exhausted. The display will
shortly go blank and the camera will stop
working. Replace or recharge the battery.
G
!
If you close the lens cover or switch to photography
or playback mode while the date setting confirmation
message is displayed, the date and time are not set
(NO ). In this event, proceed from step
"SETTING THE DATE AND TIME" (➡P.21).

SETTING THE DATE AND TIME

1
0 2
1Press the "MENU/OK" button to display the
menu screen.
2Use "d", "c", "a( )" or "b(
"SET–UP" from the "
3Press the "MENU/OK" button.
If the date was cleared and you selected
"SET DATE/TIME", proceed from step
1
in
(➡P.22).
2
1 0 3 0
1The "SET–UP" screen appears. Use "a(
or "b( )" to select "DATE/TIME".
)" to select 2Press "c".
G
!
OPTION" menu.
See P.100 for more information on the "
menu.
G
!
If at least 3 hours have passed since the AC power
adapter was connected or the battery inserted and
date and time set, then those settings will be
maintained for roughly 2 hours even when the
3
camera has no power supply (when the AC power
adapter is disconnected and the battery is removed).
1 0 2 0
1
)"
OPTION"
21