Turning The 3D Glasses On And Off; Using 3D Cinema Technology - HP ENVY 17-2000 Getting Started Manual

Component
(1) Battery compartment
NOTE:
simply pull the tab to remove it.
(2) Nose pieces (3)
NOTE:
glasses and two additional nose pieces ship with the glasses.

Turning the 3D glasses on and off

Your 3D glasses are easy to use:
●
The 3D glasses turn on and off automatically. There is no on or off
switch.
●
When 3D content begins to play, the glasses detect an IR signal
from the computer and turn on automatically.
●
Once the 3D content begins to play, the lenses may appear to
darken and you may see some flickering as the glasses begin to turn
on.
●
The battery installed in the glasses provides approximately 150
hours of 3D viewing time. To help conserve battery power, the
glasses enter Standby if no IR signal is detected for 5 seconds.

Using 3D Cinema Technology

After you set up your 3D computer, you are ready to verify that you can
properly view the 3D content.
Be sure that your computer is connected to AC power when
NOTE:
viewing 3D content. 3D playback on the computer display requires high-
performance GPU.
The stereoscopic 3D effect works best in a darkened room. For
NOTE:
optimal 3D viewing, the screen brightness controls are also disabled
when watching 3D content.
1. To access 3D content, do one of the following:
The battery is preinstalled and may have a protective tab. If the tab is attached,
There are 3 nose pieces in different sizes. One nose piece is installed on the
Using 3D Cinema Technology
15