Basic Operation
This section provides you the basic operation by using buttons on the top of the display.
Turning on POWER
Top view
MAIN POWER
BRIGHTNESS
POWER/Standby indicator
Switching INPUT Source
INPUT
BRIGHTNESS
14
GB
When the POWER/Standby indicator is "OFF":
Press MAIN POWER on the top panel of the display.
If the power cannot be switched on by pressing MAIN POWER, first
press MAIN POWER in the "OFF" position, then while keeping INPUT
pressed, press MAIN POWER again.
When the POWER/Standby indicator lights up "red":
Press POWER on the remote control.
• When the power is switched on, the POWER/Standby indicator
lights up green and a mode indicator appears on the upper right
corner of the display.
CAUTION
Never pull the plug of the power cord before you switch off the power
by using the MAIN POWER button on the top panel.
Note
Unless external AV equipment is connected, the indicator "AV-1"
appears on the display.
Press INPUT and select the applicable input source.
AV-1
AV-2
COMPONENT1
Note
• The input source mode is skipped if the corresponding input terminal is not
connected with external equipment (except "PC").
• If you change the AV INPUT 3/AV OUT select, you can select "AV-3". See
page 29 for details.
Indicator (Example)
COMPO-1
COMPONENT2
PC
Indicator (Example)
AV-1