Table of Contents
Advertisement
Preparation
4
Mount the back cover of the display and the
system cable cover.
1 Insert the four claws on the upper side of the
cover (1) into the grooves on the rear of
the display.
2 Press the two claws on the lower side of the
cover (2) into the grooves on the rear of
the display until they produce a click sound.
3 Press the two claws on the lower side of the
cover (3) into the grooves on the rear of
the display until they produce a click sound.
5
Connect desired external equipment (e.g. DVD
player: See page 12).
6
Mount the supplied AVC system terminal cover.
1 Align the protruding part in the centre of the
cover (1) with the outside of the AVC
system.
2 Align the two claws on the lower side of the
cover (2) with the two grooves in the lower
side of the AVC system and push them
gently in.
3 Align the two claws on the upper side of the
cover (3) with the two grooves in the upper
side of the AVC system and push them
gently in.
Removing the AVC system terminal cover
1 Press both of your thumbs against the
arrow marks (2 locations) on the upper side
of the cover and pull out gently to release
the claws on the upper side.
2 Now pull away the entire cover to release
the claws on the lower side.
Note
• Before connecting the power cord, be sure to set the MAIN POWER button on the top of the display to "OFF".
• When not using the unit for extended periods of time, be sure to always unplug the power cord.
• The display and the AVC system do not operate independently. Be sure to always plug in the both cords in order to
operate the display.
• When connecting external equipment to the AVC system, be sure to always establish these connections first before
plugging in the power cords of the display.
• Do not remove the system cables while the unit is operating. This could lead to defects.
• Do not place anything over the ventilation openings on the top of the AVC system.
10
GB
1
2
1
1
1
2
3
3
3
1
2
3
2
1
2
3
Advertisement
Table of Contents
