Loading The Bypass Tray With Paper - Sharp AJ-6020 Operation Manual

LOADING THE BYPASS TRAY WITH PAPER

If you wish to print on banner paper or another paper type not loaded into the main paper
tray, use the bypass feed. Only one sheet of paper (or up to 5 sheets of banner paper (only
for printing)) can be placed in the bypass tray at a time.
Open the bypass tray located on the rear of the unit.
1
Load the paper so that the side to be printed or copied onto is face up.
2
Align the paper with the right side of the bypass tray.
To use the bypass tray in the copy mode
To use the bypass tray in the copy mode, follow the steps shown below.
1) Open the bypass tray to set paper, referring step 1 and 2 above.
2)
Press the "START" button (
Paper will be automatically fed into the unit to be copied.
You cannot make multiple copies using the bypass tray. Set the paper knob to the
"Thick Paper (
To use the bypass tray in the printer mode
To use the bypass tray in the printer mode, follow the steps shown below.
1) Select the bypass tray as a paper source on the printer driver, and send the print job.
For details of the printer driver setup, refer to "Printer Properties" in the Online Manual.
"Please set a sheet of paper on bypass and press the START button" message will
appear on the Print Status Window (See Online Manual). And the following message
will appear on the display panel.
2) Open the bypass tray to set paper, referring step 1 and 2 above.
3)
Press the "START" button (
The unit will start printing.
When printing more than one page:
The message described above will also appear when printing of the first page has
been completed. Load the paper again for the next page, and then press the "START"
button ( ). Repeat this process for each page.
).
)" setting when copying onto thick paper. (See page 7.)
Load selected paper
into bypass slot
).
23