Connecting A Pc; Viewing An Image From A Pc; Displaying An Image From A Pc - Sharp Aquos LC-20B6E Operation Manual

Connecting a PC

Viewing an Image from a PC

Use the PC-IN terminal to connect a PC.
NOTE
• This LCD TV set is compatible with VESA-standard DDC 1/DDC 2B.
• Be sure to read the operation manuals of the devices to be connected before making connections.
• Make sure to select the same signal values for the output signal of a PC and the input signal of the LCD TV set before connecting with the
PC. (See pages 36 and 37.)
• Depending on the PC being used, images may not be shown without converting the output signals into external output. Please refer to your
PC's manuals regarding converting to external output.
Signal names for 15-pin mini D-sub connecter
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11

Displaying an Image from a PC

To view an image from a PC, perform the following procedure.
1 Select the PC mode using INPUT on the remote control or the LCD TV set. (See page 11.)
2 Select the PC input signal. (See page 36.)
3 Select the PC sound input mode. (See page 18.)
4 Adjust the "Fine sync." items if the PC image does not come in clearly. (See page 36.)
Connecting the thumbscrew cable
• Connect the thumbscrew cable
making sure that it fits correctly
into the terminal. Then, firmly
secure the connectors by
tightening the screws on both
sides of the plug.
• Do not remove ferrite cores
attached to the RGB cable.
Pin No. Signal name
1
R
2
G
3
B
4
Not connected
5
CSYNC
NOTE
• Pin No. 5 on the LCD TV set is not used for inputting the signal.
• Pin No. 9 is not connected with the supplied RGB cable.
To ANALOG RGB To ANALOG RGB
input terminal output terminal
RGB cable (supplied)
ø3.5 mm stereo minijack cable
(commercially available)
To AUDIO
input terminal
To Audio output
terminal
Ferrite core
Pin No. Signal name
6
GND (Ground)
7
GND (Ground)
8
GND (Ground)
9
5V
0
GND (Ground)
PC
Pin No. Signal name
q
Not connected
w
SDA
e
HD
r
VD
t
SCL
35