For
*For installation of the DC Spark Box refer to the LP Conversion instructions in this manual.
1) Remove the screw holding the fl ue connector
plate to the appliance.
2) Slide the plate out and attach to the fl ue liner
inside the fi replace to the fl ue collar with three
sheet metal screws.
3) Place the appliance on the hearth. Push
the appliance into the fi replace and at the
same time slide the plate back onto the ap-
pliance.
4) Replace the screw holding the plate just
before completely pushing the appliance into
the fi replace.
Note: Do not operate unit if fl ue connector is not
fastened in original position.
®
Regency
E21-3 Gas Fireplace Insert
PROPANE
Units and Units Equipped with DC Spark Boxes*
FLUE CONNECTOR INSTALLATION
INSTALLATION
13