Frymaster PERFORMANCE PRO SERIES 45 Service And Parts Manual page 9

35-Series Non-CE Standard
Burner Manifold Gas Pressures
Gas
Natural
Propane
35-Series CE Standard
Burner Manifold Gas Pressures
Gas
Natural Gas Lacq
(G20) under 20 mbar
Natural Gas Gronigue*
(G25) under 25 mbar
Natural Gas Gronigue*
(G20) under 20 mbar
Propane
(G31) under 37 or 50 mbar
* Belgian G25 and G20 = 9.0 mbar
8. Use a fl at-head screwdriver to adjust the gas valve regulator adjustment screw to obtain the prescribed
pressure written on the rating plate or one of the charts above. (Use the diagram on below to locate
this screw.) Turn the screw clockwise to increase gas pressure and counterclockwise to decrease gas
pressure.
9. On non-CE units, reinstall the gas valve regulator cap screw when the correct manifold pressure is
obtained.
10. Place the gas valve in the OFF position. Remove the fi tting from the pressure tap hole and reinstall the
pressure tap plug.
11. Place the gas valve in the PILOT position. Re-light and check for any gas leaks.
12. Place the gas valve in the OFF position.
To access the pilot adjustment
screw on non-CE valves, this cap
must be removed.
Locating the gas valve regulator adjustment screw and pilot adjustment screw.
Pressure
4.0" W.C.
0.87 kPa
9.0" W.C.
2.24 kPa
Pressure
9 mbar
11 mbar
11 mbar
22.5 mbar
Pilot Adjustment Screw
Gas Valve Regulator
Adjustment Screw
Honeywell Valve
(Non-CE Units)
45-Series Non-CE Standard
Burner Manifold Gas Pressures
Gas
Natural
Propane
45-Series CE Standard
Burner Manifold Gas Pressures
Gas
Natural Gas Lacq
(G20) under 20 mbar
Natural Gas Gronigue*
(G25) under 25 mbar
Natural Gas Gronigue
(G20) under 20 mbar
Propane
(G31) under 37 or 50 mbar
* Belgian G25 = 7.0 mbar
Honeywell Valve
(CE Units)
1-4
Pressure
3.5" W.C.
0.73 kPa
8.25" W.C.
2.05 kPa
Pressure
7.5 mbar
10 mbar
10 mbar
20.6 mbar