Table of Contents
Advertisement
Figura 21. Battery installation
7. Replace the computer cover, and connect the cables. See Capitolo 4,
8. Turn on the computer and all attached devices.
9. Use the Setup Utility program to set the date and time and any passwords. See
Replacing the hard disk drive
This section provides instructions on how to replace the hard disk drive.
To replace the hard disk drive, do the following:
20
Hardware Installation and Replacement Guide
"Completing the parts replacement", a pagina 31.
Nota: When the computer is turned on for the first time after battery
replacement, an error message might be displayed. This is normal after
replacing the battery.
ThinkCentre User Guide, "Using the Setup Utility."
Attention
Do not open your computer or attempt any repair before reading the "Important safety
information" in the Safety and Warranty Guide that was included with your computer for
the computer. To obtain copies of the Safety and Warranty Guide, go to
http://www.lenovo.com/support.
Important
When you receive a new hard disk drive, you also receive a set of Product
Recovery discs. The set of Product Recovery discs will enable you to restore the
contents of the hard disk to the same state as when your computer was
originally shipped from the factory. For more information on recovering
factory-installed software, refer to "Recovering software" in your User Guide.
1. Remove the computer cover. See "Removing the cover" a pagina 9.
2. Remove the bezel and drive bay assembly. See "Accessing system board
components and drives" a pagina 10.
3. Disconnect the signal and power cables from the rear of the hard disk drive.
4. Use the blue handle to pivot the hard disk drive and bracket upward, slide
the hard drive to the left until it is free of the retaining clips in the bottom of
the chassis, and then completely remove it from the chassis.
Advertisement
Table of Contents
