Replacing A Mouse - Lenovo THINK CENTRE 9126 Guida Alla Sostituzione E All’installazione Dell’hardware Manual

6. Go to Capitolo 4, "Completing the parts replacement", a pagina 31.

Replacing a mouse

This section provides instructions on how to replace a mouse.
1. Remove any media (diskettes, CDs, or tapes) from the drives, shut down your
2. Unplug all power cords from electrical outlets.
3. Locate the mouse connector.
Figura 38. Mouse connectors
4. Disconnect the failing mouse cable from the computer.
5. Connect the new mouse to the appropriate connector on the computer.
6. Go to Capitolo 4, "Completing the parts replacement", a pagina 31.
30
Hardware Installation and Replacement Guide
Attention
Do not open your computer or attempt any repair before reading the "Important safety
information" in the Safety and Warranty Guide that was included with your computer for
the computer. To obtain copies of the Safety and Warranty Guide, go to
http://www.lenovo.com/support.
operating system, and turn off all attached devices.
Nota: Your mouse might be connected to a standard mouse connector 1 or a
USB connector 2 in the front or rear of your computer. See "Locating
connectors on the rear of your computer" a pagina 5 or "Locating controls and
connectors on the front of your computer" a pagina 4.