Figura 30. Removing the heat sink
5. Lift the heat sink and fan assembly off the system board.
6. Position the new heat sink on the microprocessor socket, and then position the
Figura 31. Clamping the heat sink to the plastic retention bracket
7. Connect the microprocessor fan cable to the microprocessor fan connector on
8. Go to Capitolo 4, "Completing the parts replacement", a pagina 31.
clamp on the plastic retention bracket. Pivot the handle 1 to clamp the heat
sink to the plastic retention bracket.
the system board.
Capitolo 3. Installing options and replacing hardware
25