Frymaster FOOTPRINT H50 Service And Parts Manual page 16

2. Remove the blower motor shield and separate the blower motor from the housing as shown in
the illustration on the following page.
3. Wrap the motor with plastic wrap to prevent water from entering it. Spray degreaser or
detergent on the blower wheel and the blower housing. Allow it to soak for five minutes. Rinse
the wheel and housing with hot tap water, then dry with a clean cloth.
Wrap the motor and wires with
plastic wrap or a plastic bag.
4. Remove the plastic wrap from the blower motor assembly. Reassemble the blower motor
assembly and blower housing. Reinstall the blower shield.
5. Reinstall the blower assembly in the fryer and reconnect the wiring disconnected in Step 1.
Remove these screws to
remove the shield from the
blower assembly.
Blower Wheel
1-11
Remove these nuts to
separate the blower
motor from the housing.
Blower Housing