Xerox DocuPrint C1110 User Manual page 15

interrupter is normally in the Reset position
(where the RESET button is in a pressed-in
state). Check once a month if the ground
fault interrupter works properly in
accordance with the following procedures:
1. Switch off the product.
2. Press the TEST button located on the
rear right side of the product, with a
thin stick or similar object.
3. Make sure that the RESET button is
popped up.
4. After the confirmation, press the
RESET button to exit the test mode.
RESET button
TEST button
If the circuit does not work properly, contact
your local Fuji Xerox representative.
Do not attempt to remove a paper jammed
deeply inside the product, particularly a
paper wrapped around a fuser or a heat
roller. Otherwise, it may cause injuries or
burns. Switch off the product promptly and
contact your local Fuji Xerox
representative.
Ventilate well during extended operation or
mass printing. It may affect the office air
environment due to odor such as ozone in
a poorly ventilated room.
Provide proper ventilation to ensure safety
and comfort of the office environment.
Consumable
Store all consumables in accordance with
the instructions given on its package or
container.
Use a broom or a wet cloth to wipe off
spilled toner. Never use a vacuum cleaner
for the spills. It may catch fire by electric
sparks inside the vacuum cleaner and
cause explosion. If you spill a large volume
of toner, contact your local Fuji Xerox
representative.
Never throw a toner cartridge into an open
flame. Remaining toner in the cartridge
may catch fire and cause burn injuries or
explosion.
If you have a used toner cartridge no longer
needed, contact your local Fuji Xerox
representative for its disposal.
Never heat the drum cartridge or scratch its
surface. It may cause health hazard.
Keep the drum cartridge and toner
cartridges out of the reach of children. If a
child accidentally swallows toner, spit it out,
rinse mouth with water, drink water and
consult a physician immediately.
When replacing the drum cartridge and
toner cartridges, be careful not to spill the
toner. In case of any toner spills, avoid
contact with clothes, skin, eyes and mouth
as well as inhalation.
If toner spills onto your skin or clothing,
wash it off with soap and water.
If you get toner particles in your eyes, wash
it out with plenty of water for at least 15
minutes until irritation is gone. Consult a
physician if necessary.
If you inhale toner particles, move to a fresh
air location and rinse your mouth with
water.
If you swallow toner, spit it out, rinse your
mouth with water, drink plenty of water and
consult a physician immediately.
Fuser Safety
When removing the fuser unit, always
switch off first and wait for 40 minutes until
it cools off.
15
Safety Notes