Xerox DocuPrint C1110 User Manual page 118

Message
One Side Printed
Load Paper in
Tray 1 with
Print-side Down
Open Front Cover
Clear Jam
Open Tray 1
Clear Jam
Open & Close
Front Cover
Open Tray1/Front
Clear Jam
Open & Close
Front Cover
Out of Memory
Press SET
PDF Print
Disabled
Press SET
PDL Error
Press SET
Press SET
to continue
Ready (B/W Only)
Replace Toner [X]
(X: Y, M, or C)
Ready to Print
Drum Cartridge
Ready toPrint
Reorder Spare
Ready to Print
Fuser Unit
Ready to Print
Reorder Spare
118
6 Troubleshooting
The job requested manual 2-sided printing.
Stack the prints and load them as they are with the blank side facing up into the tray
1.
After loading the paper, the [Press SET] message appears. Press the <Eject/Set>
button to start printing.
Refer to
• "3.4 Manual 2-sided Printing" (P. 51)
A paper jam occurred in the printer.
Open the front cover and find the jammed area. If you see the jammed paper,
remove it from the printer. Then, close the front cover.
Refer to
• "6.1 Clearing Paper Jams" (P. 100)
A paper jam occurred in the tray 1.
Pull out the tray 1 to identify the jammed area, and remove the jammed paper. Then,
open and close the front cover. Open the front cover even when there is no jammed
paper inside the cover. The error will not clear unless you open and close the front
cover.
Refer to
• "6.1 Clearing Paper Jams" (P. 100)
A paper jam occurred in the printer.
Open the front cover and find the jammed area. If you see the jammed paper,
remove it from the printer. If you cannot remove the jammed paper, pull out the tray 1
to remove the paper. Then, open and close the front cover.
Refer to
• "6.1 Clearing Paper Jams" (P. 100)
The job cannot be printed due to insufficient memory.
Cancel the job by pressing the <Eject/Set> button on the control panel.
Reduce the number of files to print and try printing again. If the same message keeps
appearing, we suggest you to install additional memory.
The PDF file may be print-prohibited.
PDF files that are prohibited to print cannot be printed on the printer. Cancel the job
by pressing the <Eject/Set> button on the control panel.
An error occurred while processing the job.
Cancel the job by pressing the <Eject/Set> button on the control panel.
Check if there is any problem with the print data.
Press the <Eject/Set> button on the control panel to start printing.
If the <Eject/Set> button is not pressed for 5 seconds, the printer will start printing
automatically.
Refer to
• "3.4 Manual 2-sided Printing" (P. 51)
The X toner cartridge has run out of toner.
Replace the X toner cartridge.
The printer continues printing in monochrome even when this message appears.
The drum cartridge needs to be replaced soon. Have a new cartridge ready.
The fuser unit needs to be replaced soon. Have a new fuser unit ready.
Symptom/Cause/Remedy