Admin Menu - Xerox DocuPrint C2535 A User Manual

Admin Menu

This menu contains 7 sub menus, [Network Settings], [ParallelSettings], [USB Settings],
[System Settings], [Maintenance Mode], [PostScript], and [Panel Settings].
Network Settings
Specifies printer settings affecting jobs sent to the printer through a network port.
Note
• The settings in the [Network Settings] cannot be set when entering this menu during printing.
• You need to restart the printer to activate the new settings. After making the settings, turn off the printer
and then turn it on again.
Item
Ethernet
TCP/IP
Get IP Address
IP Address,
Subnet Mask,
Gateway Address
Protocol
50
4 Setting on the Control Panel
Specifies the communication speed and the modes of Ethernet.
• [Auto] (default)
Automatically changes between 10Base half, 10Base full, 100Base half, and
100Base full.
• [10Base Half]
• [10Base Full]
• [100Base Half]
• [100Base Full]
Specifies the settings to use the TCP/IP protocol.
Specifies whether to automatically or manually retrieve the IP address.
• [DHCP/Autonet] (default)
Automatically sets the IP address.
• [BOOTP]
Uses BOOTP to set the IP address automatically.
• [RARP]
Uses RARP to set the IP address automatically.
• [DHCP]
Uses DHCP to set the IP address automatically.
• [Panel]
You can set the IP address manually by entering it on the operator panel.
These items are used to check the addresses that have been obtained automatically or
to specify addresses manually. Enter the address in the format of xxx.xxx.xxx.xxx. You
can specifies values in the range of 0 to 255 for xxx.
Important
• To set addresses manually, set the [Get IP Address] to [Panel].
• IP addresses are managed in the entire network. An incorrect IP address may affect
the whole network. For the addresses you need to set manually, contact your network
administrator.
Set [Enable] when using the protocol. When [Disable] is selected, the protocol cannot
be activated.
• [LPD] (default: [Enable])
• [Port9100] (default: [Enable])
• [IPP] (default: [Enable])
• [SMB TCP/IP] (default: [Enable])
• [SMB NetBEUI] (default: [Enable])
• [FTP] (default: [Enable])
• [SNMP]-[UDP] (default: [Enable])
• [StatusMessenger] (default: [Enable])
• [InternetServices] (default: [Enable])
Description