Fuji Xerox DocuPrint P255 dw User Manual page 100

• Using Ad Hoc Connection
To configure the wireless settings for an ad-hoc connection where the wireless devices communicate
directly with each other without an access point:
1
On the operator panel, press the
2
Select Admin Menu, and then press the
3
Select Network, and then press the
4
Select Wi-Fi Setup, and then press the
5
Select the desired access point, and then press the
If the desired access point does not appear:
Select Manual Setup, and then press the
a
Enter the SSID, and then press the
b
Use the or
cursor.
Select Ad-hoc, and then press the
c
Select an encryption type, and then press the
d
IMPORTANT:
• Be sure to use one of the supported encryption methods to protect your network traffic.
6
Enter the WEP key, and then press the
Use the or
7
Select a transmit key from WEP Key 1, WEP Key 2, WEP Key 3, and WEP Key 4.
8
Wait a few minutes until the printer restarts to establish the wireless network.
9
Print a System Settings page from the operator panel.
Press the
a
Select Report/List, and then press the
b
Select System Settings, and then press the
c
The System Settings page is printed.
10
Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
NOTE:
• When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
• If the wireless setting does not work, contact your system administrator or Fuji Xerox Customer Support
Center.
100 Printer Connection and Software Installation
(Menu) button.
button to enter the desired value, and press the
button to enter the desired value, and press the
(Menu) button.
button.
button.
button.
button.
button.
button.
button.
button.
button.
button.
button.
or button to move a
or button to move a cursor.