Replacement Procedure - Xerox DocuPrint 3055 User Manual

Important
• Make sure that the power is on when replacing the print cartridge. Switching the power off erases the
print data in the printer and information accumulated in the memory.
• Do not expose the print cartridge to direct sunlight or strong light.
• Avoid exposure to strong light when installing the print cartridge and complete the installation in less
than one minute.
• Do not touch the surface of the photoconductor (drum). Do not place the print cartridge upright or upside
down. Doing so can damage the photoconductor (drum).
• The photoconductor (drum) protection shutter protects the photoconductor (drum) from exposure to
light.
• Do not open the photoconductor (drum) protection shutter unless necessary.
• We recommend you to use up the print cartridge within one year after removing it from the packaging.
• Place the print cartridge only on a flat surface.
Place the side with the handles facing up.

Replacement Procedure

Use the following procedure to replace the print cartridge and to clean inside the printer.
1. If paper is loaded in the bypass tray,
remove the paper and close the bypass
tray cover.
Important
• When closing the bypass tray cover, be careful not to
get your fingers caught between (the left or right edge
of) the cover and the printer.
2. Pull the front cover release levers ("A")
towards you and open the front cover.
3. Open the top cover.
7.1 Replacing Consumable
161