Xerox DocuPrint 3055 User Manual page 151

Message
Open Tray 3, 2
& 1. Clear Jam
then
Open & Close A
Out of memory
Press SET
and Cancel JOB
PDF file secured
Press SET
and Cancel JOB
PDL Error
Press SET
and Cancel JOB
Push in
all trays
Push in Tray N
(N: tray 1 - 4)
Push in trays
Ready to print
Maintenance Kit
Ready to print
Replace soon
Ready to print
Toner Cartridge
Ready to print
Replace soon
Reboot printer
(***-***)
Set Tray N
xx xx xxxx
(N: tray 1- 4)
SysError ***-***
Reboot printer
A paper jam occurred in the printer.
Pull out the tray 1, tray 2, and tray 3 to identify the jammed area, and remove the
jammed paper. Then, open and close the front cover. Open the front cover even
when there is no jammed paper inside the cover. The error will not clear unless you
open and close the front cover.
Refer to
• "6.1 Clearing Paper Jams" (P. 133)
The job cannot be printed due to insufficient memory.
Cancel the job by pressing the <Eject/Set> button on the control panel.
Reduce the number of files to print and try printing again. If the same message keeps
appearing, we suggest you to install additional memory.
The PDF file may be print-prohibited.
PDF files that are prohibited to print cannot be printed on the printer. Cancel the job
by pressing the <Eject/Set> button on the control panel.
An error occurred while processing the job.
Cancel the job by pressing the <Eject/Set> button on the control panel.
Check if there is any problem with the print data.
The job requested a paper tray, but one of the trays above it is open.
Close the open tray.
The tray N is open.
Push the tray firmly into the printer.
One of the trays is open when printing.
Push the tray firmly into the printer.
The maintenance kit (regular replacement part) needs to be replaced soon. Have a
new maintenance kit ready.
The print cartridge needs to be replaced soon. Have a new cartridge ready.
The printer may be at fault.
Switch the power off, wait for the display to go out, and switch the power back on
again. If the same error code is displayed, copy down the error code (***-***), and
contact our Customer Support Center or your dealers.
Refer to
• "Error Codes" (P. 153)
The size of the paper loaded in the tray N does not match the paper size requested
by the job.
Load the paper indicated in the message (xx xx xxxx) in the tray N.
Refer to
• "Loading Paper in the Trays 1 - 4" (P. 85)
A system error occurred.
Switch the power off, wait for the display to go out, and then switch the power back
on. If the same error code is displayed, copy down the error code (***-***), and
contact our Customer Support Center or your dealers.
Refer to
• "Error Codes" (P. 153)
Symptom/Cause/Remedy
6.6 Error Messages and Error Codes
151