Xerox DocuPrint 3055 User Manual page 111

[TCP/IP]
Set this when using the TCP/IP port.
Network / Port
TCP/IP
Setting Item
Get IP Address
IP Address,
Subnet Mask,
Gateway Address
TCP/IP
Get IP Address
TCP/IP
IP Address
TCP/IP
Subnet Mask
TCP/IP
Gateway Address
Sets the method of obtaining the information (the IP address, subnet mask, or
gateway address) required to use the TCP/IP protocol.
• [DHCP/Autonet] (default)
Automatically obtains the information from the DHCP (Dynamic Host
Configuration Protocol) server that has the AutoIP feature.
• [Panel]
Sets the information manually on the control panel. Consult your network
administrator for the IP address number.
• [DHCP]
Automatically obtains the information from the DHCP server.
• [BOOTP]
Automatically obtains the information from the BOOTP.
• [RARP]
Automatically obtains the information from the RARP.
Note
• After changing this setting, reboot the printer.
Allows you to verify or manually enter the IP address.
Enter the IP address in the format of:
xxx.xxx.xxx.xxx
For IP or gateway addresses, xxx can be any number between 0 and 255.
However, the first xxx cannot be 127 or a number between 224 and 255.
For subnet masks, each xxx must be one of the following numbers:
0, 128, 192, 224, 240, 248, 252, 254, and 255. (See *2 on P. 132.)
Important
• Make sure you set the IP address correctly. Setting the wrong address can
cause problems on the network.
Note
• After changing this setting, reboot the printer.
Description
5.2 Setting the Common Menus
111