Xerox DocuPrint C3055 User Manual page 152

Message
Ready to print
Replace (***-***)
Ready to print
X Toner
Ready to print
Replace soon
(X: Black Cyan, Magenta, or
Yellow)
Reboot printer
(***-***)
Remove
Drum Cartridge
Replace Drum
Cartridge
Replace
Fuser Unit
Replace X
Toner Cartridge
(X: Black Cyan, Magenta, or
Yellow)
SysError ***-***
Press SET
SysError ***-***
Reboot printer
Unknown paper
type. Press SET
152
6 Troubleshooting
The part needs to be replaced soon.
Copy down the "***-***" and contact our Customer Support Center or your dealers.
Refer to
• "Error Codes" (P. 154)
The toner in the X toner cartridge is low. Have a new cartridge ready.
The printer may be at fault.
Switch the power off, wait for the display to go out, and switch the power back on
again. If the same error code is displayed, copy down the error code (***-***), and
contact our Customer Support Center or your dealers.
Refer to
• "Error Codes" (P. 154)
When installing the printer, make sure to load the toner cartridges before the drum
cartridge.
Switch the power off, remove the drum cartridge from the printer, switch the power
back on, and follow the message displayed on the display to load the toner cartridges
and then the drum cartridge.
Refer to
• "Replacing the Drum Cartridge" (P. 168)
It is time to replace the drum cartridge.
Replace the drum cartridge.
It is time to replace the fuser unit.
Replace the fuser unit.
The X toner cartridge has run out of toner.
Replace the X toner cartridge.
Refer to
• "Replacing the Toner Cartridges" (P. 164)
A system error occurred.
Copy down the error code (***-***) on the display, and contact our Customer Support
Center or your dealers.
Pressing the <Eject/Set> button on the control panel clears the error.
Refer to
• "Error Codes" (P. 154)
A system error occurred.
Switch the power off, wait for the display to go out, and then switch the power back
on. If the same error code is displayed, copy down the error code (***-***), and
contact our Customer Support Center or your dealers.
Refer to
• "Error Codes" (P. 154)
The printer was requested by the job to automatically select a paper tray when the
[Paper Priority] setting for all paper types are set to [Off].
Cancel the print job by pressing the <Eject/Set> button on the control panel.
Set the priority order of the paper trays or manually select a paper tray on the control
panel.
Refer to
• "[System Settings]" (P. 113)
Symptom/Cause/Remedy