Xerox DocuPrint C3055 User Manual page 149

Message
Install X
Toner then
Close Top Cover
(X: Black Cyan, Magenta, or
Yellow)
Invalid feature
Press SET
Invalid job
Press SET
Limit reached
Press SET
Load in Bypass
xx xx xxxx
Load in Tray
xx xx xxxx
Load in Tray N
xx xx xxxx
(N: tray 1- 4)
Load in Tray N
A4 Landscape
Load in Tray N
Plain
Load in Tray N
Check Guides
Login Error
Press SET
Load the X toner cartridge and close the top cover. If you close the top cover, the
cartridge slot rotates allowing you to install the next cartridge.
Refer to
• "Replacing the Toner Cartridges" (P. 164)
If the Authentication feature is used, you are not registered as a user who is
authorized to print in color. Cancel the job by pressing the <Eject/Set> button on the
control panel.
For information about the user registration, consult your system administrator.
The job was not printed since the request is not valid.
This message may appear when the accessory configuration settings differ from the
actual configuration (for example, you requested 2-sided printing when the duplex
unit is not installed, but it is set to [Available] on the print driver).
Cancel the job by pressing the <Eject/Set> button on the control panel.
Correctly specify the print request and try printing again.
If the Authentication is used, the number of pages permitted to print has reached the
maximum.
Cancel the job by pressing the <Eject/Set> button on the control panel.
For information about the maximum print pages setting, consult your system
administrator.
The size of the paper loaded in the bypass tray does not match the paper size
specified by the job.
Load the paper indicated in the message (xx xx xxxx) in the bypass tray.
Refer to
• "Loading Paper in the Bypass Tray" (P. 81)
The printer was requested by the job to automatically select a paper tray, but the
paper size settings of all trays do not match the paper size specified by the job.
Load paper of the size specified by the job in the appropriate paper tray.
Refer to
• "Loading Paper in the Trays 1 - 4" (P. 83)
The size of the paper loaded in the tray N does not match the paper size requested
by the job.
Load the paper indicated in the message (xx xx xxxx) in the tray N.
Refer to
• "Loading Paper in the Trays 1 - 4" (P. 83)
The paper in the tray N is not A4 Plain Paper and is not loaded in landscape
orientation. Or, the paper guides are not adjusted to A4. The paper guide position for
A4, especially for the rear guide, can be easily mistaken for that of the Letter size
(8.5).
Load the correct paper or adjust the paper guides properly.
The Authentication feature is enabled but you are not authorized to print from the
printer. Or, when you requested the job, you did not correctly enter your user ID and
password on your print driver.
Enter the correct user ID and password and try printing again.
Consult your system administrator whether you have access to the printer.
Refer to
• "7.8 Authentication and Auditron Administration Features" (P. 188)
Symptom/Cause/Remedy
6.6 Error Messages and Error Codes
149