Connecting To A Vcr Or Other Similar Device - Philips HDR3500 User Manual

Step 2: Optional Connections
Antenna
A
TV-OUT ANTENNA-IN
B
Connecting to a VCR or
other similar device
This connection enables you to record
from a video tape to the hard disk. The
connected VCR can be used for playback
even when the recorder is turned off.
Note:
Your new recorder can replace the VCR
for all your recording needs. Just unplug
all the connections to your VCR.
A
Connect the existing antenna cable (it can
be from the off-air wall socket or Cable
Box) to the ANTENNA-IN
on the recorder.
B
Connect an RF antenna cable from the
TV-OUT socket on the recorder to
the antenna input socket on your TV
(usually labelled as ANT, ANTENNA IN,
RF IN).
20
HDR3500_05_eng_30381.indd 20 HDR3500_05_eng_30381.indd 20
VHF/UHF
RF IN
??
?
???
??
??
? ???
???
VHF/UHF
Cable
RF OUT
EXT 2 TO VCR/SAT EXT 1 TO TV
S-VIDEO IN
SCART IN
socket
(continued)
SCART IN
SCART OUT
D
CVBS OUT
Y P B
L
P
R
R
S-VIDEO OUT AUDIO COAXIAL COMPONENT
VIDEO OUT AUDIO OUT DIGITAL OUT VIDEO OUT
TV
C
C
Connect a scart cable (not supplied) from
the EXT1 TO TV socket on the
recorder to the corresponding scart
input socket on the TV.
D
Connect another scart cable (not
supplied) from the EXT2 TO VCR/
SAT socket on the recorder to the scart
output socket on the VCR (usually
labelled as TV OUT or TO TV).
Helpful Hints:
– Most commercial video cassettes and
DVDs are copy-protected and therefore
cannot be recorded.
– Connect the recorder directly to the TV. If
there is a VCR or an additional device in
between, the picture quality may be poor
because of the copy protection system built
into this recorder.
Back of a VCR
(Example only)
2008-02-27 10:51:37 AM 2008-02-27 10:51:37 AM