Connecting To A Vcr Or Other Similar Device - Philips DVDR3575H User Manual

Step 2: Optional Connections
EXT 1
TV-OUT ANTENNA-IN
B
Connecting to a VCR or
other similar device
This connection enables you to record
from video tape to hard disk and allows
the VCR to be used for playback on the
TV if the recorder is turned off.
Note:
Your new recorder can replace the VCR
for all your recording needs. Just unplug
all the connections to your VCR.
A
Connect the existing Antenna cable (it
can be from the off-air wall socket or
Cable Box) to the ANTENNA-IN
socket on the recorder.
B
Connect a RF antenna cable (supplied)
from the TV-OUT
recorder to the antenna input socket on
your TV (usually labelled as ANT,
ANTENNA IN, RF IN).
20
VHF/UHF
RF IN
VHF/UHF
RF OUT
HDMI
OUT
TO TV EXT 2 TO VCR/SAT
L
AUDIO
AUDIO OUT
socket on the
(continued)
VCR (example only)
SCART IN
SCART OUT
D
CVBS OUT
R
COAXIAL S-VIDEO OUT
VIDEO OUT
DIGITAL OUT
TV
C
C
Connect a scart cable (supplied) from the
EXT1 TO TV socket on the recorder
to the corresponding SCART socket on
the TV.
D
Connect another scart cable (not
supplied) from the EXT2-TO VCR/
SAT socket on the recorder to the Scart
socket (usually labelled as TV OUT or
TO TV) on the VCR.
Helpful Hints:
– Most commercial video cassettes and
DVDs are copy-protected and therefore
cannot be recorded.
– Connect the recorder directly to the TV. If
there is a VCR or an additional device in
between, the picture quality may be poor.
MAINS