Error Code - Philips VR20D/07 User Manual

68
EN

Error Code

Some error codes may appear on the TV screen when operating the recorder. Refer to the chart below for the solution.
ERROR CODE
102 When a signal in which only the analog
information is copy protected has been input for
the dubbing in D-VHS mode.
103 When a signal which is digitally copy protected
has been input for dubbing in D-VHS mode.
104 When a signal which cannot be digitally converted
by the recorder has been recorded.
105
When making an S-VHS/VHS recording of a signal
from DV IN connector (i.Link).
200
When a signal which cannot be digitally converted
by the recorder has been input and played back.
201
When normal playback is impossible such as with
a mosaic (block-shaped noise).
205
When an attempt is made to play back a D-VHS
recorded tape that has been found to be invalid.
300
When a signal which cannot be digitally converted
by the recorder has been input.
SYMPTOM
TROUBLESHOOTING (cont.)
SOLUTION
It is not possible to record a digitally copy protected
signal.
It is not possible to record a digitally copy protected
signal.
Sometimes a programme can be recorded but not
played back because the signal system is not
supported by the recorder. Switch to analog input
such as "L-1" to record.
The recorder's DV IN connector (i.Link) is especially
for D-VHS recording. The digital signal is not
converted to analog and then recorded. Switch to
analog input such as "L-1" to record.
Playback is impossible because a signal system not
supported by the recorder has been input.
The recorder is making adjustments in order to
display normal picture. Please wait.
This tape cannot be played back by this recorder.
Nothing can be seen or heard because the signal
system is not supported by the recorder.