Philips VR20D/07 User Manual page 20

+
1
-
4
7
+
-
MENU
IMPORTANT
In certain reception conditions, station names may not be
stored correctly, and auto Guide Program Number Set may
not work properly. If the Guide Program numbers are not set
properly, when you timer-record a TV programme using the
VIDEO Plus+ system, the recorder will record a TV
programme of a different station. When programming the
timer using the VIDEO Plus+ system, be sure to check
whether the channel position on which your recorder
receives the broadcasting station you wish to record is
selected ( pg. 30, "VIDEO Plus+
Your video recorder memorizes all detected stations even if
reception of some of them is poor. In these cases picture
quality may be poor. To delete those stations with an
unacceptable picture
+
2 3
-
5 6
8 9
0
PROG. +
PROG. –
+
-
OK
®
Timer Programming").
"Delete A Channel" on page 59.
VIEW CONFIRMATION
SCREEN
4
After "SCAN COMPLETED"
is displayed on the screen
for about 5 seconds, the
Confirmation screen
looking like the one to the
right appears. The stations
your recorder located
appear on a Confirmation
screen — channel
positions (PR), channels
(CH) and station names
(ID – pg. 62). The blueback screen and the
programme currently being broadcast by the blinking
station appear alternately for 8 seconds each.
To view the next page, use the %fi
remote control.
The Guide Program numbers will also be set
automatically during Auto Channel Set.
RETURN TO NORMAL
SCREEN
5
Press MENU.
Using the Confirmation screen, you can skip or add
channel positions, enter station names and perform
other operations. Refer to pages 58 – 61 for the
procedures.
Depending on reception conditions, the stations may
not be stored in order, and the station names may not
be stored correctly.
For information on scrambled broadcasts, refer to
page 59.
NOTES:
Fine tuning is performed automatically during Auto Channel
Set. If you want to perform it manually, refer to page 60.
If you perform Auto Channel Set when the aerial cable is not
connected properly, "SCAN COMPLETED -NO SIGNAL-"
appears on the screen in step 7. When this happens, make
sure of the aerial connection and press OK; Auto Channel Set
will take place again.
57
EN
PR CH ID PR CH ID
01 26 BBC1 08 ––––
02 33 BBC2 09 ––––
03 23 ITV 10 ––––
04 30 CH4 11 ––––
05 37 CH5 12 ––––
06 –––– 13 ––––
07 –––– 14 ––––
[ 5 ∞
]
=
: EDIT
= [X] : DELETE
[MENU] : EXIT
@ #
button on the