Table of Contents
Advertisement
Troubleshooting & Tips
Your choices are as follows:
Abort: Halts the rebuild process. You may elect to retry at a later date.
Break ECC on Target Drive: If the error is detected on the source drive, "Break
ECC on Target Drive" means that FastTrak will copy the bad data sector on to
the target drive to assure that both drives are identical. If the error is detected
on the target drive, FastCheck will copy the data contained in the good sector
of the source drive again to the target drive.
Skip the Error Block: RAID Function will log the event error and continue the
rebuild process. Use this setting if you want to detect the presence of errors,
but do not want to fix these errors at the time. You may then decide what to do
about the error(s) detected.
ECC Error Reported on Synchronize
The following screen will appear if a data error is detected on either source or target
drive during Synchronize if you have set the On Errors setting to "Interactive" within
FastCheck's Options Window for Scheduled Synchronization (see page 43) or for
Manual Synchronization under Notification options (see page 42).
5 7
Advertisement
Table of Contents
