Dram Configuration - Gigabyte GA-890FXA-UD5 User Manual

DRAM Configuration

CPU Host Clock Control
x CPU Frequency(MHz)
Set Memory Clock
x Memory Clock
DCTs Mode
DDR3 Timing Items
x CAS# latency
x RAS to CAS R/W Delay
x Row Precharge Time
x Minimum RAS Active Time
x 1T/2T Command Timing
x TwTr Command Delay
x Trfc0 for DIMM1
x Trfc2 for DIMM2
x Trfc1 for DIMM3
x Trfc3 for DIMM4
x Write Recovery Time
x Precharge Time
x Row Cycle Time
higf : Move Enter: Select
F5: Previous Values
x RAS to RAS Delay
** DCTs Drive Strength **
ProcOdt(ohms)
DQS Drive Strength
Data Drive Strength
MEMCLK Drive Strength
Addr/Cmd Drive Strength
CS/ODT Drive Strength
CKE Drive Strength
Bank Interleaving
Channel interleave
DQS Training Control
CKE Power Down Mode
Memclock tri-stating
higf : Move Enter: Select
F5: Previous Values
CPU Host Clock Control, CPU Frequency (MHz), Set Memory Clock, Memory Clock
The settings under the four items above are synchronous to those under the same items on the MB In-
telligent Tweaker(M.I.T.) main menu.
DCTs Mode
Allows you to set memory control mode.
Ganged Sets memory control mode to single dual-channel.
Unganged Sets memory control mode to two single-channel. (Default)
DDR3 Timing Items
Manual allows all DDR3 Timing items below to be configurable.
Options are: Auto (default), Manual.
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
DRAM Configuration
[Auto]
200
[Auto]
x6.66
[Unganged]
[Auto]
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
+/-/PU/PD: Value
F6: Fail-Safe Defaults
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
DRAM Configuration
Auto
DCT0
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
[Enabled]
[Skip DQS]
[Disabled]
[Disabled]
+/-/PU/PD: Value
F6: Fail-Safe Defaults
1333Mhz
SPD Auto
7T 7T
7T 7T
7T 7T
30T 30T
-- --
5T 5T
90ns 90ns
-- --
-- --
-- --
10T 10T
5T 5T
28T 28T
F10: Save
4T 4T
DCT1
60 [Auto] 240
1.0x [Auto] 1.5x
1.0x [Auto] 1.5x
1.5x [Auto] 1.5x
1.5x [Auto] 2.0x
1.5x [Auto] 2.0x
1.5x [Auto] 2.0x
F10: Save
- 41 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
BIOS Setup