Paper Handling - Epson Stylus COLOR 3000 User Manual

Paper handling

Single sheets do not feed properly
Single sheets do not feed properly from the sheet feeder.
Cause
Too many sheets may be
loaded in the sheet feeder.
Paper is curled or folded.
The paper may be too thick
or too thin to be fed.
The edge guides are not set
correctly.
Continuous paper may be left
in the paper path.
The paper-release lever may
be set to the wrong position.
The rear edge guide may not
be correctly placed under the
output tray.
The rear edge guide does not
match the length of index
cards loaded.
Paper has been compressed
and is sticking together.
What to do
Remove the paper from the feeder and
reload up to 100 plain paper sheets (or
up to 70 special coated sheets, or up to
30 sheets of oversized paper).
Use flat, non-damaged paper.
See "Paper" on page D-4.
Adjust the guides against the stack of
paper.
Remove the continuous paper.
Set the paper-release lever to the
single-sheet position.
Fit the rear edge guide under the
output tray to match the paper loaded
in the sheet feeder.
Position the rear edge guide as shown
in "Photo Quality Ink Jet Card" on
page 5-25.
Fan your stack of paper before loading
it into the sheet feeder.
Troubleshooting
8
8-17