Changing The Default Settings - Epson Stylus COLOR 3000 User Manual

Parallel I/F transfer rate
This setting specifies the I/F (interface) transfer rate for the
parallel interface. For most printing, leave this setting set to
Fast. If you encounter problems, set it to Normal.

Changing the default settings

To change the printer's default settings, use the control panel
buttons; the control panel lights show your selections.
1. Make sure the printer is turned off and at least 4 sheets
of A4 (210 mm) size or wider paper are loaded printable
side down in the sheet feeder.
Note:
You can also load paper from the manual feed slot or the tractor
feeder.
2. Hold down the Media Type button and turn on the printer to
enter the default-setting mode.
The printer loads a sheet of paper and prints a brief
summary and instructions. It instructs you to select the
language that you want messages printed in (English,
French, German, Italian, Spanish, or Portuguese).
3. Press the Micro Adjust
indicate the language of your choice; then press the Pause
button to make your selection.
6-10
The Control Panel
button until the following lights