Packard Bell ixtreme M5801 Service Manual page 82

BIOS Messages
Keyboard Error Or
No Keyboard
Present
Keyboard is locked
out - Unlock the key
Memory Test:
Memory test fail
Override enabled -
Defaults loaded
Press TAB to show
POST screen
Primary master hard
disk fail
Primary slave hard
disk fail
Secondary master
hard disk fail
Secondary slave
hard disk fail
76
Cannot initialize the keyboard. Make sure the keyboard is attached correctly and no
keys are pressed during POST. To purposely configure the system without a
keyboard, set the error halt condition in Setup to HALT ON ALL, BUT KEYBOARD.
The BIOS then ignores the missing keyboard during POST.
This message usually indicates that one or more keys have been pressed during the
keyboard tests. Be sure no objects are resting on the keyboard.
This message displays during a full memory test, counting down the memory
areas being tested.
If POST detects an error during memory testing, additional information appears giving
specifics about the type and location of the memory error.
If the system cannot boot using the current CMOS configuration, the BIOS can
override the current configuration with a set of BIOS defaults designed for the most
stable, minimal-performance system operations.
System OEMs may replace the Phoenix Technologies Award BIOS POST display
with their own proprietary display. Including this message in the OEM display
permits the operator to switch between the OEM display and the default POST
display.
POST detects an error in the primary master IDE
hard drive.
POST detects an error in the secondary master IDE
hard drive.
POST detects an error in the primary slave IDE hard drive.
POST detects an error in the secondary slave IDE
hard drive.
Action/FRU