Specifying Both Original Size And Copy Size Separately - Toshiba e-STUDIO3510c Operator's Manual

3 SETTING OF BASIC COPY MODES

Specifying both original size and copy size separately

1
Place paper in the drawer(s).
2
Place the original(s).
3
Press the Enlargement/Reduction ([ZOOM...]) button.
4
Specify the original size and copy paper size.
Original size:
Copy paper size: Press the size button representing the desired copy paper size.
E.g.: When LD for the original size and LT for the copy paper size are selected
The copy paper size can also be set by pressing the drawer button on the touch
panel.
When the original size and copy paper size have been specified, the enlargement/
reduction ratio is computed and displayed on the touch panel.
Set other copy modes as required.
When the original or copy paper is a standard size other than LD, LG, LT or ST, you need
to register this paper size in the selections of the [OTHER] button in advance. See "When
a standard size paper other than LD, LG, LT and ST-R is set" below for the registration.
5
Press the [START] button.
104 Enlargement and Reduction Copying
Press the size button representing the same size as that of the set orig-
inal.