Placement; Mounting (Rack) - Tripp Lite SmartOnline SU10KRT3/1X Owner's Manual

4 – Mounting
continued

4-2 Placement

In order to minimize the possibility of damage to the UPS system and maximize its operational lifespan, follow the location warnings listed in
Section 2 – Important Safety Instructions. Remember to keep at least 30 cm clearance from the rear panel of the UPS system to the wall and
do not block any of the UPS system's front or rear ventilation openings.
Warning: The UPS system is very heavy—be careful when moving or lifting it.

4-3 Mounting (Rack)

• Use the included rackmount shelves and mounting hardware to mount the UPS system in a 4-post rack or rack enclosure. To mount the UPS
system in a 2-post (telecom) rack, order Tripp Lite's 2-Post Rackmount Kit (model 2POSTRMKITWM, sold separately).
• The instructions in this manual are for common rack and rack enclosure types and may not be appropriate for all mounting applications. The
user must determine the fitness of hardware and procedures before mounting. If hardware or procedures are not suitable for the application,
contact the manufacturer of the rack or rack enclosure for a solution.
• For further mounting instructions, see the Owner's Manual for Tripp Lite Model No. BP240V10RT3U.
4-Post Mounting Procedure
Note: The mounting procedure is identical for the external battery pack and the UPS power module. Mount the external battery pack
first, then repeat the procedure for the UPS power module. The external battery pack should be mounted in the lowest available rack
space. The UPS power module should be mounted directly above the external battery pack.
1
Adjust the depth of the mounting shelves
nuts through the smaller square holes of the shelves, then attach the shelves to the rack's vertical mounting rails. (The shelves should face
N1
inward.) Use M5 flat-head screws
screws before proceeding.
2
Use M4 flat-head screws
3
Use M3 flat-head screws
4
With the aid of an assistant, lift the cabinet and place it on the mounting shelves. Insert M5 pan-head screws
brackets and into the vertical mounting rails. Tighten all screws securely.
N1
B3
S3 B5
1
and to fit the rack, then mount the shelves in the lowest available rack space. Insert cage
B4
B3
for the front and rear vertical rails; use washer plates
S3
to attach pulls to the mounting brackets
S2 B1
to attach the mounting brackets to the cabinet.
S1
B4
.
B2
N1
2
3
S3
4
6
for the front vertical rails only. Tighten all
B5
through the mounting
S4
B2
S2
B1
S1
S4