Measuring Resistance - UNI-T UT60B Operating Manual

Model UT60B/C/E: OPERATING MANUAL
Measurement Operation (3)
C.Measuring Resistance
(see figure 5)
Warning
To avoid damages to the Meter or to the devices under test,
disconnect circuit power and discharge all the high-voltage
capacitors before measuring resistance.
The resistance ranges are: 400.0 , 4.000k , 40.00k
400.0k , 4.000M and 40.00M . To measure resistance,
connect the Meter as follows:
1. Insert the red test lead into theHzV terminal and the black
test lead into theCOM terminal.
2. Model UT60C/UT60E:
Set the rotary switch to
( ) is default or press BLUE button to select
mode.
Model UT60B:
Set the rotary switch to
) is default or pressBLUE
measurement mode.
3. Connect the test leads across with the object being measured.
The measured value shows on the display.
Note
l The test leads can add 0.1
measurement. To obtain precision readings in low-resistance
measurement, that is the range of 400.0
input terminals beforehand, using the relative measurement
function button REL
measured when the testing leads are short-circuited
from the reading.
(figure 5)
button to select
to 0.2
automatically subtract the value
to
16
,
; resistance measurement
measurement
, resistance measurement
of error to resistance
, short-circuit the