U-Line 2115R Service Manual page 63

Section 3 - Service and Repair
NOTE: If door is adjusted correctly, but panel is not square with the
adjacent cabinets, slight adjustments can be made by drilling the holes
in the vinyl-coated steel panel slightly oversized (Figure 37).
Rear View
of
Wood Panel
1" ± 1/32"
ADJUSTING DOOR ALIGNMENT
1. Remove top hinge screw pin using a Phillips screwdriver (Figure
38). Remove door by tilting forward and lifting off bottom hinge
pin.
2. With door upside-down, loosen but do not remove the two
screws on the door's bottom hinge plate.
3-48
Drill 5/32" x 3/8" Deep for use
with #10 x 5/8" Wood Screw
and Nylon Spacer – 6 Places
27" ± 1/4"
14-5/16" ± 1/4"
1" ± 1/8"
1" ± 1/32"
ULIN_0310_A
Figure 37
ULIN_0133_A
Figure 38
Slotted
Mounting
Holes
Raise Lower
Outside Outside
Door Edge Door Edge
Figure 39
3. See Figure 39 and Figure 40. If the top far edge of the door
needs to move UP, move the hinge plate toward the outside of the
door and retighten screws. If the top far edge of the door needs to
move DOWN, move the hinge plate toward the inside of the door
and retighten screws.
Slotted
Mounting
Holes
Raise
Outside
Door Edge
2115WC, 2115WCOL, 2175WC, 2175WCOL Only
Figure 40
4. Mount the door to recheck alignment and repeat steps 2 and 3 if
further adjustment is necessary.
5. When top edge of door is parallel to top edge of cabinet, remove
the door and ensure the two screws are secure.
6. Remove the door closers from the bottom hinge, clean thoroughly
and lubricate the mating surfaces with petroleum jelly.
7. Reinstall the closers, lining up the bosses with holes in hinge and
hinge plate (Figure 41).
Notch must face center of door
ULIN_0297_A
Angled Edge
Towards Center
of Door
Lower
Outside
Door Edge
ULIN_0311_A