Peripheral Setup - TYAN S1846 Tsunami ATX User Manual

Chapter 4
BIOS Configuration

Peripheral Setup

Peripheral Setup options are displayed by choosing Peripheral Setup
from the AMIBIOS Setup main menu. All Peripheral Setup options are
described here.
Power Interruption
OnBoard FDC
OnBoard Serial Port1
OnBoard Serial Port2
Serial Port2 Mode
**IR Duplex Mode
**Receiver Pin
OnBoard Parallel Port
Parallel Port Mode
**EPP Version
**Parallel Port DMA Channel
OnBoard IDE
** Setting is not Selectable
Power Interruption
The settings are Enabled or Disabled.
Onboard FDC
Set this option to Enabled to enable the floppy drive controller on the
motherboard. The settings are Auto, Enabled, or Disabled.
Onboard Serial Port1
This option specifies the base I/O port address of serial port 1. The
settings are Auto, Disabled, 3F8h, 2F8h, 3E8h, or 2E8h.
Onboard Serial Port2
This option specifies the base I/O port address of serial port 2. The
settings are Auto, Disabled, 3F8h, 2F8h, 3E8h, or 2E8h.
Fail-Safe Default
Disabled
Auto
3F8h
2F8h
Normal
N/A
IRRX1
378
Normal
N/A
N/A
Both
64
Optimal Default
Disabled
Auto
3F8h
2F8h
Normal
N/A
IRRX1
378
Normal
N/A
N/A
Both
http://www.tyan.com