Peripheral Setup - TYAN S1846 User Manual

Chapter 4
BIOS Configuration

Peripheral Setup

Peripheral Setup options are displayed by choosing Peripheral Setup from the
AMIBIOS Setup main menu. All Peripheral Setup options are described here.
Power Interruption
OnBoard FDC
OnBoard Serial Port1
OnBoard Serial Port2
Serial Port2 Mode
**IR Duplex Mode
**Receiver Pin
OnBoard Parallel Port
Parallel Port Mode
**EPP Version
**Parallel Port DMA Channel
OnBoard IDE
** Setting is not Selectable
Power Interruption
The settings are Enabled or Disabled.
Onboard FDC
Set this option to Enabled to enable the floppy drive controller on the
motherboard. The settings are Auto, Enabled, or Disabled.
Onboard Serial Port1
This option specifies the base I/O port address of serial port 1. The settings
are Auto, Disabled, 3F8h, 2F8h, 3E8h, or 2E8h.
Onboard Serial Port2
This option specifies the base I/O port address of serial port 2. The settings
are Auto, Disabled, 3F8h, 2F8h, 3E8h, or 2E8h.
Serial Port2 Mode
This option specifies the operating mode for serial port 2.This option will not
appear if the Onboard Serial Port2 option is set to Disabled, or is set to Auto
and your system does not have an onboard serial port 2. The settings are
Normal, Sharp-IR, IrDA, and Consumer. (EXPLAIN)
Fail-Safe Default
Disabled
Auto
3F8h
2F8h
Normal
N/A
IRRX1
378
Normal
N/A
N/A
Both
60
Optimal Default
Disabled
Auto
3F8h
2F8h
Normal
N/A
IRRX1
378
Normal
N/A
N/A
Both
http://www.tyan.com