TurboChef TORNADO Quick Manual page 3

Stacking HhC 2020 Ovens
WARNING: DO NOT use this appliance without the legs installed on the bottom oven.
WARNING: Make sure all HhC 2020 ovens are unplugged before stacking.
WARNING: DO NOT stack ovens more than 3 high.
WARNING: DO NOT attempt to lift the oven with fewer than 2 people.
1. Remove the legs from the oven(s) that are going to be stacked on top.
2. Cover the leg holes with the abrasive pads provided with kit HCT-3001.
3a. If the front panel on each oven contains side hinges, skip to step 4.
3b. If the front panel on the ovens that are going to be stacked on top contain
bottom hinges (adjacent), ensure that a thumb screw is installed on each side
to allow for front panel removal. If the oven has security screws, replace them
with the thumb screws provided with kit HCT-3001.
4. Stack the top oven on the bottom oven. If stacking three ovens, stack only the
middle oven at this point.
5. Remove the 6 screws marked A or B in the illustration below.
6. Align each bracket with the holes in the bottom oven and reinstall the screws marked A in the illustration below.
7. Align each bracket with the holes in the top oven and reinstall the screws marked B in the illustration below.
8. If stacking three ovens, repeat steps 2-6 above to stack the top oven to the middle oven.
9. Ensure each stacked oven is secured to the oven beneath it via two stacking brackets – one on each side.
B
Bracket
A
A
Stacking HhC 3240 Ovens
Follow all instructions in the Installation Manual (part number HHC-6651), included with each oven.
Step 3b: Must be
Thumb Screw
B
Bracket
A
A
DOC-1032/Revision F/
February 2013