Optical Indication Of Theft Protection; Keycard; Replacing A Keycard - Blaupunkt Madrid RCM 105 Operating Instructions Manual

Optical indication of theft protection

When the car is stationary, you can let the
KeyCard tongue flash in order to show that
the set is theft-protected. DSC allows you to
adjust two different settings: LED ON or LED
OFF.
For more information, please read through
chapter "DSC programming - LED ON/OFF".

KeyCard

The car radio can only be operated using
either KeyCard 1 or 2. Their codes are stored
in the unit.
Turn on the set and introduce the KeyCard
completely. The car radio is now ready for
operation. When inserting a wrong KeyCard,
the display will show "----".
After approximately 10 seconds, "CARD
ERR" will appear in the display. In this case
do not make any further adjustments until
you have the corresponding KeyCard avail-
able.
Never try to pull out the KeyCard by force.
First, slightly press the card in. This releases
the KeyCard; the display
"LEARNING". Now you can pull out the card.
Should the KeyCard be lost or damaged,
then please contact one of our authorised
service partners to get a new card.
24
The service centres are marked ( ) in the car
radio service centre list. In case of doubt,
please contact the central service centre in
your country for more information on the
KeyCard service centre closest to you.
Use either KeyCard (1 and 2) to individually
store the following functions as desired:
bass, treble, balance and fader settings, pre-
set stations, loudness, TA (traffic announce-
ment volume), SPEECH (tone control for
speech programs), BEEP volume, SCANTI-
ME, VOLFIX.
Moreover, the parameters adjusted last such
as the station, TA priority, loudness, AF, RM,
REG ON/OFF or seek tuning sensitivity
remain stored.
With this, you will always find your basic
settings adjusted again after you have inser-
ted your KeyCard.

Replacing a KeyCard

Any KeyCard can only be replaced by a new
one with the same identification number
(1 or 2).
For example, to replace KeyCard 2,
shows
• insert KeyCard 1 into the set and turn it
on.
• Slightly push in the card so that it is
released; the display will show
LEARNING.
• Take out KeyCard 1 and insert the new
KeyCard 2 while the display is still
showing LEARNING.
You can now use the new KeyCard 2 to
operate the set.
To turn it on, you can only employ one Key-
Card 1 or 2.