Diagnosing With The Leds - HP ProCurve Wireless Access Point 530 Installation And Getting Started Manual

Diagnosing with the LEDs

Table 5-1 shows LED patterns on the access point that indicate problem
conditions.
1. Check in the table for the LED pattern that you see on your access point.
2. Refer to the corresponding diagnostic tip on the next few pages.
Table 5-1. LED Error Indicators
LED Pattern Indicating Problems
Power LED
Off with power cord plugged in
Off without power cord plugged in,
but linked to a PoE source
Prolonged on or off during
†
initialization
On
On
On
* This LED is not important for the diagnosis.
†
Initialization takes between 30 seconds and one minute after a power on or reset.
Radio LEDs LAN LED
*
*
Prolonged on or off Prolonged on or off
†
during initialization during initialization
Off
* Off with cable
connected
* On, but the port is not
communicating
Troubleshooting
Diagnosing with the LEDs
Diagnostic
Tips
* 1
* 2
3
†
* 4
5
6
5-3