Baby Lock Ellisimo GOLD BLSOG Instruction And Reference Manual page 315

m
Pull out about 8 cm (approx. 3 inches) of
bobbin thread.
n
Lightly hold the end of the upper thread
while turning the handwheel toward you
(counterclockwise) until the mark on the
handwheel aligns with the center top of
machine.
o
Gently pull the upper thread to bring the
bobbin thread up through the needle plate.
→ A loop of the bobbin thread comes out through the
hole in the needle plate.
p
Insert tweezers through bobbin thread loop
and pull bobbin thread above the needle
plate.
q
Align the upper thread and bobbin thread,
and then pull out about 10 cm (approx.
4 inches) of the threads and pass them
under the presser foot toward the rear of
the machine.
PREPARING FOR BOBBIN WORK
r
Install the bobbin cover.
a Bobbin cover
→ This completes the upper and lower threading.
CAUTION
• When creating bobbin work, use the bobbin
cover with tabs, otherwise the thread may
become tangled or the needle may break.
Note
• If utility stitches are to be used, refer to
"CREATING BOBBIN WORK (SEWING)" on
page 314. If embroidery patterns are to be
used, refer to "CREATING BOBBIN WORK
(EMBROIDERY)" on page 318.
7
313