Baby Lock Ellisimo GOLD BLSOG Instruction And Reference Manual page 313

a
mark
b
mark
c Bobbin case
Note
• The bobbin case (gray) cannot be used for
sewing in any way other than bobbin work.
After sewing bobbin work, refer back to the
steps in "Preparing the Bobbin Thread" on
page 310 for removing and cleaning the
bobbin case (gray), and then reinstall the
standard bobbin case (black).
CAUTION
• Be sure to use the bobbin case (gray) when
creating bobbin work. Using any other bobbin
case may result in the thread becoming
tangled or damage to the machine.
• Make sure that the bobbin case is correctly
installed. If the bobbin case is incorrectly
installed, the thread may become tangled or
the machine may be damaged.
h
Install the needle plate cover.
For details on installing the needle plate cover,
refer to "Cleaning the Race" on page 326.
a Needle plate cover
PREPARING FOR BOBBIN WORK
i
Install the flat bed attachment or
embroidery unit.
j
Insert the thread tail from the spool of
thread through the hole in the bobbin from
the inside to the outside. Hold the thread
tail while winding the thread around the
bobbin by hand. After winding the bobbin
so it is filled as shown below (about 80%),
cut the thread.
For precautions on winding the bobbin for
embroidering, refer to step
Pattern" on page 318.
CAUTION
• Use a bobbin thread that has been correctly
wound. Otherwise, the needle may break or
the thread tension will be incorrect.
• The included bobbin was designed specifically
for this sewing machine. If bobbins from other
models are used, the machine will not operate
correctly. Use only the included bobbin or
bobbins of the same type (part code: X52800-
150).
* Actual size
a This model
b Other models
c 11.5 mm (approx. 7/16 inch)
Note
• Slowly and evenly wind the thread around
the bobbin.
• For best results, wind the bobbin so the
thread is snug and not twisted.
b
of "Selecting the
311
7