Thread Indicator; Tail Stock; Rests - Axminster CQ6230A-2/910 User Manual

transverse direction. This movement may be effected automatically or
manually.
D. When short cones have to turned by hand, the cross piece may be
swiveled at 90° towards the lower slide in both directions and be fixed in the
required position by the help of suitable bolts and nuts.
E. The top slide on which the four-position tool holder is mounted, may be
shifted only by hand in the direction of the cross-piece.
Thus you may obtain longitudinal, cross and combined feed for the cutting tool.
THREAD-INDICATOR
This device is mounted to the carriage box (disengaged to the driving screw)
for getting into thread pitch

TAIL STOCK

The tailstock is clamped to the corp. guide ways. It is designed for working
piece clamping during machining between centers for drilling operations with
manual feed of the tool.

RESTS

In response to the special request of the client, the lathe may be competed
additionally with a steady and a follow rest.
The two types are with sliding quills. The steady rest is fixed to the corp. guide
ways and the follow rest to the carriage board.
Page - 11 -
OWNER'S MANUAL