Rules For Safe Operation - Axminster Excalibur EX-16 User Manual

To help ensure safe operation, please take a moment to learn the machine's
applications and limitations, as well as potential hazards. Axminster Tool
Centre disclaims any real or implied warranty and holds itself harmless for any
injury that may result from the improper use of its equipment.
1. Be sure to read, understand and follow all safety warnings and
instructions in the supplied Operator's Manual.
2. Do not operate the saw when tired, distracted, or under the
effects of drugs, alcohol or any medication that impairs reflexes or
alertness. Stay alert! Give your work your undivided attention.
3. Keep the work area well lit, clean and free of debris. Cluttered
areas and benches invite injuries.
4. Keep children and shop visitors at a safe distance while
operating the saw; do not permit them to operate the scroll saw.
5. Childproof and tamper proof your shop and all machinery with
locks, master electrical switches and switch keys, to prevent
unauthorized or unsupervised use. Fine particulate dust is a
carcinogen that can be hazardous to health. Work in a well
ventilated area and use a dust collector whenever possible.
7. Wear approved safety glasses, dust mask and
non-skid footwear. Do not wear loose clothing, gloves, bracelets,
necklaces or jewellery while operating the saw. Keep long hair
contained by wearing protective hair covering.
8. Be sure all adjustment tools, wrenches or other
clutter are removed from the machine and/or the table surface
before operation. When not in use, tools should be locked-up in a
dry place, out of children's reach and away from flammable
substances.
9. Keep hands well away from saw blade and all
moving parts. Use a brush, not hands, to clear away chips and
sawdust.
ed full operating speed before beginning to cut.
11. Do not push or force stock into the blade. The saw will perform
better and more safely when working at the rate for which it was
designed. Do not use for purposes not intended.

Rules for Safe Operation

12. Avoid working from awkward or off balance
positions. Do not overreach while cutting; keep both feet on floor.
Never lean over or reach behind the blade and never pull the
workpiece through the cut from behind.
13. Never stand or lean on the saw. Serious injury could occur if
the unit is tipped over or if the blade is unintentionally contacted.
14. Use of parts and accessories NOT recommended by Axminster
Tool Centre may result in equipment
malfunction or risk of injury.
15. Never leave the machine unattended while
running or with the power "ON".
16. Always turn off and disconnect from power source before
servicing or changing accessories, blades, bits, and cutters, or
before performing any maintenance or adjustments.
17. Make sure that switch is in the "OFF" position before plugging
in the power cord. Do not use the saw if the power switch is
defected, have defective switches replaced by an authorized
service centre.
18. Make sure saw is properly grounded. If equipped with a 3-
prong plug it should be used with a three-pole receptacle. Never
remove the third prong. Avoid body contact with grounded
surfaces (e.g. pipes, radiators, stoves, refrigerators).
19. Repairs to the saw should only be carried out by qualified
people using original spare parts. A guard or other damaged part
should be properly repaired or replaced by an authorized service
centre.
20. Inspect power cords and extension wires
periodically. If damaged, have them repaired by an authorized
service facility. Never yank cords and wires and keep away from
heat, oil, and sharp edges.
21. This tool is for indoor use only. Do not expose to rain or use in
wet or damp locations.
03