Table of Contents
Advertisement
7
Secure tool rest (A, Fig. 3) to tool rest body (B, Fig. 3) by tightening handle(C, Fig. 3).
Fig. 3
1. Headstock Lock Handle: (D, Fig.4) Locks head in position. Unlock handle to position the
head along lathe bed. Tighten handle when properly positioned.
2.. Headstock On/Off Button: (F, Fig.4) Pull the button out to turn "ON" the lathe. Push the
button in to turn the lathe "OFF".
3. Headstock RPM Knob: (G, Fig. 4) Turn knob to desired RPM. There are two speed
ranges offering "speed" (330-3200) and "torque" (100-1200).
4. Headstock For/Rev Switch: (H, Fig. 4) Use the toggle switch to change the direction the
spindle turns. Only change direction when the spindle has stopped.
5. Headstock RPM Readout: (I, Fig. 4) Displays the spindles RPM, see Figure 5.
6. Headstock Spur Center: (J, Fig. 6) Used for turning between centers. Spindle taper is
MT-2. Remove spur center by inserting drift rod through the opposite end of the spindle and
knocking spur center out.
Fig. 5
7. Headstock Faceplate: (K, Fig. 6) Used for turning bowls and plates. There are a number
of screw holes for mounting the workpiece. Thread the faceplate onto the spindle in a
WOODLATHE MANUAL
CONTROLS & FEATURES
Fig. 4
Fig. 6
Advertisement
Table of Contents
