Remote Control Replacement Instructions - Friedrich KUHL R-410A Service Manual

Replacement Remote Control Configuration Instructions
For Use with Kühl
Contents:
•
Remote Control with Holder
•
(2) AAA-batteries
•
Instruction Sheet
ATTENTION! – You May Need to Configure The Replacement Remote Control
Please read instructions completely before attempting configuration of the Remote Control. Failure to
do so could result in the Remote Control not being able to operate the Air Conditioning Unit properly.
Step 1. A. Locate the Model # of your Air Conditioner.
B. Identify the prefix (First 2 Letters) of your unit's model #.
C. Look at the chart below and in it, find the prefix of your AC unit's model #.
D. Note the Option # Code (OPT#) next to it and the required action. The unit's
display is supposed to show this OPT# Code.
Model Prefix
SS, SM
SL
YS, YM, YL, ES, EM, EL
Point the Remote Control at Air Conditioning Unit and then press the Remote Control's
Step 2.
Key once to illuminate the Air Conditioning Unit's display.
POWER
Once the display on the Air Conditioning Unit is illuminated, check the Option Code
Step 3.
number (OPT#) shown in the display and ensure it matches the OPT# code for your unit
as per the chart above.
and Kühl +
(cool only models)
Option Code
OPT 1
OPT 2
OPT 3
Air Conditioner Unit's Display
OPT1
OPT2
OPT3 Displayed example
Figure 1
(cool & heat models)
Required Action
None –
Remote Control configured for use with air conditioner
Perform Steps 2 - 5
Perform Steps 2 - 5
(see example below Fig 1)
Kühl Remote Control
77