Figure - Axminster AT1628VS User Manual

Assembly Instructions
Remove the headstock, tool rest assembly
and tailstock from the lathe bed as before
to make it easier to assemble the stands
2. After removing the above lift the lathe bed using a
scissor lift, lifting host or seeking help.
3. Place the stands (F) to each end of the lathe bed
and line up the holes in the stands with threaded
holes in the lathe bed, secure using the 3/8" bolts and
washer (c),see figures 10-11-12-13.
4. Replace the headstock, tool rest and tailstock. (See

figure 14)

Figure 10
Figure 11
Figure 12
c
F
c
Lathe Extension Assembly (Code: 502704)
The lathe extension (H) bolts onto either end of the
lathe bed which increases the length of the lathe for
turning larger projects. The lathe extension can also
be mounted to the stands for turning large diameter
projects.
Assembly 1
1. Locate the lathe extension (H) and 3/8" Hex bolts
and washers (d). Remove the tailstock stop pin from
the end of the lathe, see figure 15 and place safely
aside.
2. Line up the centre hole in the lathe extension (H)
with the lathe bed centre pin, see figure 16, push on
the lathe extension so it's flush against the lathe bed,
line up the holes and secure using the 3/8" Hex bolts
and washers (d). (See figure 17)
8
Use a lifting device as a scissor lift for example to
raise the lathe bed to mount the lathe stands
Adjust the feet (G) until the lathe is level
Figure 13
Figure 14
G