Voltage Check Type - Autopage RS-620 Installation Manual

Enter Start Feature 'D' Programming Mode:
1. Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF
position.
2. Push the Valet switch 9 times (holding in on the 8th push) until four
chirps with a long chirp is heard then release the valet switch. You are
now in the Start feature 'D' programming mode.
Select "Checking Type":
3. Press the transmitter
Type". [2] LED flash, [2] horn chirp to confirm this setting
Once you complete step 3, you can adjust and test "Start Timer" as
below:
VOLTAGE START PROGRAMMING: (TEST & ADJUST)
While the system stay in Start Feature "D" programming mode,
1. Press the
2. If everything goes well: Wait for 10 seconds:
a. If the engine still running.
I. Press the
You have completed this programming successfully.
II. Press
There will be 3 long chirps & 3 parking light flashes for confirmation.
b. If the engine shuts down after the vehicle has started:
I. Press the '
II. Press
position. [1] LED flash, [1] horn chirp to confirm this setting
III. Repeat the step1 – 2.
3. If the crank time is too long, (Engine running but starter still cranks):
a. Press the
b. Press
chirp & LED pause will confirm this entry. (Decrease "Start Timer" is
necessary.)
c. Repeat the step1 – 4.
4. If the crank time is too short, (Engine is not running, starter has
stopped cranking):
a. Press the
b. Press
chirp & LED pause will confirm this entry. (Increase "Start Timer " is
necessary.)
c. Repeat the step1 – 4.
VOLTAGE CHECKING TYPE:
button on the transmitter to start the vehicle.
button on the transmitter to stop engine running.
button on the transmitter to exit the program mode.
button on the transmitter to stop engine running.
button on the transmitter to set "Check Level" to LOW
button on the transmitter to stop engine running.
button on the transmitter to set proper "Start Timer". The
button on the transmitter to stop engine running.
button on the transmitter to set proper "Start Timer". The
+ button to set the "Voltage Checking
24