Horizon Fitness CLUB CSE 3.5 User Manual page 6

A SS EM BLY ST EP 3
����������
���������������������
A) Open HARDWARE BAG FOR STEP 3.
B) Attach the PERIMETER BARS using 4 BOLTS (E).
C) Attach REAR STABILIZER COVER using 2 SCREWS (F).
D) Attach FRONT STABILIZER COVERS using 2 SCREWS (F) for each side.
HARDWARE BAG FOR STEP 3 CONTENTS :
10
CSE3.5-4.5 Elliptical Rev 0.4.indd 10-11
��������������
����������
����������������������
���������
�������� ���������
����� �����
������ ������
ASSEMBLY STEP 4
������������
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Remove PRE-ATTACHED BOLTS & WASHERS from CONSOLE MAST.
B) Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLTS & WASHERS.
C) Attach UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED SET SCREWS.
After handlebars are assembled they will rotate freely – be cautious. Until the
WARNING
machine is fully assembled, do not grab the handlebars for support.
���������������
������������
����������
������������
�������������
���������������
11
6/3/05 5:42:08 PM