ATN Aries MK300 User Manual page 5

You could change the IR control panel fitting your needs. The screw-tool included into the set
should be used for weakening the fixing screw located on the IR. Rotate the IR placing at in
the most convenient position. Tighten the screw with the screw-tool to fix the new position.
Fixation
Screw
reTicle
Aries 350 Guardian reticle gives a clearly aiming point,
even when hard-to-see game blends into the background.
Thinner posts and crosshairs center section covers a
minimum of the target and allow for less target coverage,
making precision shots on small target easy.
Heavy posts stand out against cover and leads your eye
directly to the center intersection, The result is fast precision
aming.
winDAge AnD eleVATion
The vertical and horizontal adjustments for the Aries can be
achieved by turning the elevation and windage adjustment
mechanisms (remove dust caps first). Each click equals 1/2
inch at 100 yards. When reaching the maximum range of
rotation do not use force.
cleAning The eyepiece
You may need to clean the eyepiece of the riflescope from time to time in order to guarantee
top performance. When you receive your riflescope you should check for dust on the
eyepiece of the unit.
First you will need to remove the eyepiece. To do that you will need to initially loosen the 2
set screws that can be found on the base. Then unscrew the eyepiece counter-clockwise to
remove it.
NOTE: You do not have to remove the set screws completely, they are very small and easy to misplace.
CAUTION: Use only Photographic lens cleaning tissue on these surfaces. Be careful not to scratch
or smudge any of these surfaces. When using compressed air to blow dust away, make sure to avoid
inverting the can while spraying. This can cause frozen propellant to exit the can, which can cause
serious problems with the glass and phosphor screen
Battery
Housing
IR Windage
IR Brightness
Adjustment
IR Elevation
IR Focusing
The thin lines
correspond to
5 yards at 100
yards distance
Elevation
Windage
4